Chapter 5 - System Setup Screens
5-36
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Memory – Backup
The Memory - Backup selection allows you to backup
the panel’s Project, Log files, Recipe files or even
the Firmware files to either an SD memory card or
USB pen drive. The available memory devices will be
displayed with their total and free memory.
If the device is not available, it will be grayed out. The
Next button is grayed out until a device is selected.
The Cancel button can be pressed at any time to return
to the Memory Menu screen.
This is an example of selecting a USB memory device to
write the backed up files to.
The selected device is highlighted. Pressing again
deselects it.
Even if there is only one available memory device, it still
needs to be highlighted in order to go to the next step.
Press the Next button to continue to Step 2.
Please read the explanation for the availability of SD1 under different conditions that follow:
To Next Page
Loading...