AutomationDirect C-more EA9-T7CL-R - Step 8 - Choose Touch Panel to Device Cables

Chapter 1 - Getting Started
1-13
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Step 8 – Choose Touch Panel to Device Cables
The table below shows the PLCs, controllers and protocols supported by the EA9-RHMI.
Ensure your controller and protocol are supported.
PLC Protocol Table
Model Protocols
AutomationDirect
Productivity Series
Productivity Serial
Productivity Ethernet
Do-more
(BRX)
all
Do-more Serial
Do-more Ethernet
CLICK
Modbus (CLICK addressing)
Modbus TCP (CLICK addressing)
DL05/DL06
all
K-Sequence
Direct NET
Modbus (Koyo addressing)
H0-ECOM/H0-ECOM100 Direct LOGIC Ethernet
DL105 all K-Sequence
DL205
D2-230 K-Sequence
D2-240
K-Sequence
Direct NET
D2-250/D2-250-1/D2-260/D2-262
K-Sequence
Direct NET
Modbus (Koyo addressing)
D2-240/D2-250-1/D2-260
Using DCM
Direct NET
Modbus (Koyo addressing)
H2-ECOM/H2-ECOM100 Direct LOGIC Ethernet
DL305
D3-330/330P (Requires the use of a Data Communications Unit) Direct NET
D3-340 Direct NET
D3-350
K-Sequence
Direct NET
Modbus (Koyo addressing)
D3-350 DCM
Direct NET
Modbus (Koyo addressing)
DL405
D4-430
K-Sequence
Direct NET
D4-440
K-Sequence
Direct NET
D4-450/D4-454
K-Sequence
Direct NET
Modbus (Koyo addressing)
All with DCM
Direct NET
Modbus (Koyo addressing)
H4-ECOM/H4-ECOM100 Direct LOGIC Ethernet
H2-WinPLC (Think & Do) Live V5.2 or later and Studio any version Think & Do Modbus RTU (serial port)
H2-WinPLC (Think & Do) Live V5.5.1 or later and Studio V7.2.1 or later Think & Do Modbus TCP/IP (Ethernet port)
GS Drives
GS Drives Serial
GS Drives TCP/IP (GS-EDRV)
SOLO Temperature Controllers (models with serial communications) SOLO Temperature Controller