AutomationDirect C-more EA9-T7CL-R - EA9-T15 CL-R and EA9-T15 CL Cutout Dimensions

Chapter 4 - Installation and Wiring
4-8
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
EA9-T15CL-R and EA9-T15CL Cutout Dimensions
The C-more 15” touch panels are mounted into a cutout through the control cabinet and
secured with eight (8) mounting clips. The mounting clips are provided with the touch panel.
The mounting clips will insert into a series of slots around the rear perimeter of the touch
panel. Each clip has a tab that will mate to a slot. The screw of each mounting clip needs to
be tightened to the torque rating shown in the table below so that the gasket is compressed to
form the proper seal between the panel and cabinet surface.
Enclosure Mounting Thickness Ranges
and Mounting Clip Screw Torque
Touch
Panel Size
Enclosure
Thickness Range
Mounting Clip
Screw Torque
Material
6”, 7”, 8”,
10” & 12”
0.039 - 0.20 inch
[1 – 5 mm]
63 - 77 oz-in
[0.45 - 0.55 Nm]
Metal
10” Wide,
15”
0.039 - 0.20 inch
[1 – 5 mm]
92 - 106 oz-in
[0.65 - 0.75 Nm]
Metal