Autonics CT Series Manual

Page 03 KKCTE02T-A/0-20131221
5 times
MD
ss to
99.9s)
4.Operation Procedure:
5.1.Change of the setting value of Counter
How to change
preset
: To change the preset value from 175 to 180.
PS1
PS2
BA.S
LOCK OUT1 OUT2 BA.0 CNT TMR
RST
BA MD
PS1
PS2
BA.S
LOCK OUT1 OUT2 BA.0 CNT TMR
RST
BA MD
Change by pressing or
Under measuring status , press key to enter the setting value modify status , the selected digit
always flickers from right to left.
PS1
PS2
BA.S
PS1
PS2
BA.S
LOCK OUT1 OUT2 BA.0 CNT TMR
RST BA MD
Under measuring status, press to enter
setting value modify status , press
continuously , select digit to make it flicker
Press
key to select data flickering .
PS1
PS2
Press once,change to ,then pre
confirm and return to measuring status .
PS1
PS2
BA.S
LOCK OUT1 OUT2 BA.0 CNT TMR
RST BA MD
5.2 Change the setting value of the timer
Running Mode
Change preset time
t. OFF
MD
MD
t. ON
Change delay time
In the status of changing preset value, if no press any key during 60 seconds, the timer will return to Running Mode.
How to change t. OFF time from 30 sec. to 50 sec., t.ON setting from 40 sec. to 20 sec. (Output mode: FLK, Timer range: 0.1s-999
PS1
PS2
BA.S
LOCK OUT1 OUT2 BA.0 CNT TMR
RST BA MD
Press key to enter the
status of changing preset time.
Make the data flicker by
pressing key twice.
PS1
PS2
BA.S
LOCK O UT1 OUT2 BA.0 CNT TMR
RST
BA MD
Change to by pressing
key twice.
Pressing key to complete
t.OFF time setting then enter the
status of changing t.ON time.
MD
PS1
PS2
BA.S
LOCK O UT1 OUT2 BA.0 CNT TMR
RST BA MD
Press key twice
to move the flickering
PS1
PS2
BA.S
LOCK O UT1 OUT2 BA.0 CNT TMR
RST BA MD
Pressing key to complete
the setting , then return to
RUN mode.
Press key twice to change
MD
(1)
value
(2)
“5” to “0”
(3)
(4)
“7”
“7”
“8”
1.
2.
(1)
(2)
“3”
“3”
“5”
In timing status ,press to enter setting value modify status .The of the
data
selected
flickering from right to left .
sequence
(3)
to digit “4”
(4)
“4” to “2”
“5”
5.Batch Counting and Batch Preset
Batch Output Action
Batch Reset
Batch Preset Value
0
Batch Output
Batch counting
1.
When batch counting value is beyond 999999 , it will reset to zero automatically , and restart to count.
Batch counting value is up counting , it only can be reset by the external batch reset signal .
Batch counting value is not affected by
RST
key or external reset signal.

Autonics CT Series Specifications

General

Brand	Autonics
Model	CT Series
Category	Cash Counter
Language	English