Need help?Do you have a question about the Autonics CT Series and is the answer not in the manual?
General| Brand | Autonics |
|---|---|
| Model | CT Series |
| Category | Cash Counter |
| Language | English |
Explains reading ON/OFF status of coils in slave devices.
Explains reading ON/OFF status of input references in slave devices.
Explains reading binary data from holding registers in slave devices.
Explains reading binary data from input registers in slave devices.
Explains turning single coils ON or OFF in slave devices.
Explains setting binary data for single holding registers.
Explains writing binary data to holding registers consecutively in slave devices.
Describes exception codes sent upon error and their meanings.
Maps Modbus functions for Reset and Output operations.
Maps Modbus functions for terminal input status.
Maps Modbus addresses to product-specific information.
Maps Modbus addresses to various monitoring data points.
Maps Modbus addresses for setting preset values.
Maps Modbus addresses for counter-specific function settings.
Maps Modbus addresses for timer-specific function settings.
Maps Modbus addresses for communication parameters.
To Next Page
