Page 06 KKCTE02T-A/0-20131221
If select F or N mode , when counting value reaches the preset value , output will maintain , therefore there is no
menu in function setting mode.
If S,T, D mode , input mode can only choose Ud-A,B, C mode .If input mode choose Up/Down mode , output mode can select
any mode except S , T , D
When select D output mode , if counting frequecy more than 1Kcps , as there is a responding time of the relay , it may cause the output
action abnormal , so please choose SSR output .
When max. counting spe
ed is 5kcps or 10kcps , if change the output mode to mode , counting speed turn to 1k cps automatically .
In function setting mode , external input signal still can be recognized , when exit the function setting mode , display value and output
will reset automatically .
8 .Timing function mode setting
“OUT2 output time”
output is
“D”
MD
MD
MD
MD
MD
MD
MD
MD
→
→
Up Down
→
→
U
.
Setting Mode
Selection and Setting
select output delay time
use and to select input mode .
To Next Page
Loading...
