Autonics CT Series Manual

Page 05 KKCTE02T-A/0-20131221
7. Counting function mode setting
Setting mode
Input mode
Maximum
counting speed
Output mode
OUT2 output
time
OUT1 output
time
Input logic
Min.reset time
Decimal point
Prescale value
Memory
retention
Lock key
Counter/Timer
Up or Down inut mode
Up/Down- A, B, C inut mode
Unit: ms
Unit: ms
Use or to select PnP or nPn
Unit: ms
Min. external RESET signal width
: Power reset for counting value.
(Reset counting value when power off)
: Memorize counting value
(Memorize counting value when power off)
: Counter
: Timer
When output mode is S , T ,D , the input mode only can be Ud-A , B , C.
Counting speed means the allowable maximum
inpu frequency of INA and INB . Eg: If set CPS
as 5K , when input frequency signal is larger
than 5K , the counting will be not correct.
( 、▲)
MD
MD
MD
MD
MD
MD
MD
MD
MD
MD
MD
▲
MD
▲
- - - - - - → - - - - - - →- - - - - - → - - - - - -
* * *
Shift the flickering digit
Change the prescale value
Set range of prescale value
6 Digit: 0.001 ~ 99.999
▲
▲
prescale value: It is actual length or other measure unit per one pulse
▲
Selection and setting

Autonics CT Series Specifications

General

Brand	Autonics
Model	CT Series
Category	Cash Counter
Language	English