Autonics LE4SA - Page 9

N-31
SENSORS
CONTROLLERS
MOTION DEVICES
SOFTWARE
(J)
Temperature
Controllers
(K)
SSRs
(L)
Power
Controllers
(M)
Counters
(N)
Timers
(O)
Digital
Panel Meters
(P)
Indicators
(Q)
Converters
(R)
Digital
Display Units
(S)
Sensor
Controllers
(T)
Switching
Mode Power
Supplies
(U)
Recorders
(V)
HMIs
(W)
Panel PC
(X)
Field Network
Devices
LCD Display Timer
[Figure2]
[Figure3]
[Figure4]
[Figure5]
※
Factory default
※
Factory default
※
Factory default
※
Factory default
● One-shot output time setting
● Time progress UP/DOWN setting
● The minimum input signal setting (LE4S only)
● Output contact setting (LE4SA only)
3) Press to complete output contact setting and move to the next mode.
4) If pressing for 3 sec in any function setting, it will return to Run mode.
※
Except for Star-Delta, Twin and Twin 1 modes (
2C
is set automatically)
※
If pressing in Run mode, output contact setting value will be displayed.
(if no key is pressed over 3 sec, it will enter into function setting mode.)
3) Press to complete UP/DOWN setting and move to the next mode.
4) If pressing for 3sec in any function setting mode, it will return to Run mode.
RESET, START and INHIBIT.
1) In function setting mode, if it enters into input signal setting mode, the characters will be
displayed as shown in the [Figure 4].
2) Select 1ms or 20ms using , .
When output operation mode ON Delay 2[
ONd2
],
1) In function setting mode, if it enters into One-shot output time setting mode as shown in
the [Figure 2], the last digit will ash.
2) Set One-shot output time using and . (setting range: 0.01s to 99.99s)
3) Pressing to complete one-shot output time setting and move to the next mode.
4) If pressing for 3 sec in any function setting mode, it will return to Run mode.
1) In function setting mode, if it advances to UP/DOWN setting mode, the characters will be
displayed as shown in the [Figure 3].
2) Select
UP
(▲),
DN
(▼) using , .
3) Press to complete input signal width and move to the next mode.
4) If Pressing over 3 sec in any function setting mode, it will return to Run mode.
1) In function setting mode, if it enters into output contact setting mode, the characters will be
displayed as shown in the [Figure 5].
2) Select time limit 1c+instant limit 1c or time limit 2c using , .
(refer to LE4SA Series, Connections section for output contact connections)