BT 460 车辆蓄电池检测仪使用说明书
Resistance 18.5mΩ ------Battery resistance
Life 95% -----------Battery remaining life
Test result Good ------------Battery state
Note:
(a) When battery voltage is lower than normal test voltage, the test result can not
judge the battery state. It will show “Re -test after charging”. At this time, please
charge the battery, then test it.
(b) When battery voltage is too high or the vehicle is starting, the test can’t be
proceeded. It will show “The voltage is too high. Please turn off the engine! Please
turn on the headlights in 3 minutes, then test it.”
(c) For deep loss battery (For expample, the vehicle is on hold for a long time; the battery is
not charged in time; the headlight or door is forgotten to turn off/close , which cause
battery loss deep, and vehicle can’t start), it may show “Please replace the battery” during
test. For such batteries, please consult the battery manufacturer to restore charging , then
test it.
II. Cranking Test
After battery test, press UP/DOWN key to select cranking test. Then, press ENTER
key to cranking test:
Current 12.5V ----current voltage
Minumum voltage 11.1V --------Minimum voltage tested
Minimum cranking voltage 9.6V --------Cranking voltage lower than
9.6V is regarded as abnormal, which may be caused by battery aging which can’t
provide sufficient cranking current, or because of starter worn or poor mechanical
lubrication.
In the state of engine off, it will show “Start engine, and wait for 15 seconds!”
Start engine, and wait for the test result.
III. Charging Test
To Next Page
Loading...
Need help?
General
