5
minutes, then test it.”
For serious battery shortage (For example, the vehicle is on
hold for a long time; the battery is not charged in time; the
headlight or door is forgotten to be turned off, which cause
serious battery shortage, and vehicle can’t start), it may show
“Please replace the battery” during test. For such batteries,
please consult the battery manufacturer to restore charging,
then test it.
After battery test, press UP / DOWN key to select cranking test.
Then, press ENTER key to cranking test:
●
In the state of engine off, it will show “Start engine, and wait for
15 seconds!” Start engine, and wait for the test result.
●
Cranking test
In the menu, press UP / DOWN key to select charging test.
Press ENTER key to charging test. It will show “ Start engine,
and wait for 15 seconds! Press ENTER key to start charging
test!”
At the same time, start engine. When engine running is stable,
press ENTER key to display test state:
●
●
Charging test
Current
Minimum voltage
Minimum cranking
voltage
12.5V--Current voltage
11.1V--Minimum voltage tested
9.6V--Cranking voltage lower than 9.6V
is regarded as abnormal, which may be
caused by battery aging which can’t
provide sufficient cranking current, or
because of starter worn or poor
mechanical lubrication.
Maximum
Current
14.5V <15.0V normal
11.1V--Minimum voltage tested
Minimum 13.6 >13.3V normal