Instrument parameter settings
When an acceleration performance test is carried out, set up
an acceleration target speed firstly, and finish the
acceleration performance test after the set speed is
reached. When the brake performance test is undertaken, it
is necessary to set up an initial braking speed firstly; when
the initial brake speed is reached, start to calculate the brake
distance until the car speed is stopped.
Choose instrument parameter settings, enter the
instrument parameter setting interface, and adjust the
parameter size left and right, long press the function
key to return to the previous menu.
Instrument Parameter Settings
Include the Following Contents
8
Engine displacement settings - Set up the engine
displacement size, after this parameter is set, the car's
instantaneous fuel consumption and average fuel
consumption are accurately calculated.
Fuel type setting - Choose petrol, diese1, diesel 2; in
different diesel modes, fuel consumption data sees
great changes.
Over-speed alarm - Set up this parameter, when the set
car speed is reached, the instrument will send “drop,
drop” sounds to give an alarm, the car speed text will
display in red.
High water temperature alarm - Set up this parameter,
when the engine reaches the alarm temperature
instrument, “drop, and drop” sounds will be given, at the
same time the displayed temperature character is red.
Shift reminding rotation speed - After this rotation speed
is set, shift reminding status is reached, and a shift
prompt tone will be sent, at the same time, shift
characters display.
Shift reminding upper limit - The car speed reaches the
set value, the shift reminding will be shut down, in case
there are no gears to uplift at the highest gear after the
set car speed is exceeded.
7
To Next Page
Loading...
Need help?
General
