Page - 3
2.4 Cells and Manifold Assembly
The cell assembly consists of a clear PVC housing containing titanium metal coated cell blades.
The electrolytic cell receives the low voltage DC power from the control center and initiates the
electrolytic process. This process converts ordinary table salt (Sodium Chloride) to 100% pure
Sodium Hypochlorite which in turn purifies your pool. Water from the pool circulation system is
directed through the cell. As the dissolved salt cycles through the cells, the electrolytic process
splits the sodium from the chloride and generates chlorine. After the chlorine reacts with the
organics and debris in the water, the chlorine recombines with the sodium and the process is
repeated.
The manifold assembly model #941-215AC is shown below and consists of two commercial
PPC5 cells. The Pool Pilot
®
Professional can accomodate up to a six (6) cell manifold assembly.
Please note that one power module per cell is required. See "Water Manifold Assemblies -
Available Options" on page 8.
The cell is installed with unions on each end to allow quick and easy removal.
Pool Pilot
®
Professional Cell
Figure 2
941-215AC Manifold Assy.
Figure 3
To Next Page
Loading...
