7.1.c Up or Down ( △ / ▽ ) Buttons 15
7.1.d MENU/ENTER Button 16
7.1.e TEST Button (Diagnostic Menu) 16
7.1.f WARNING Light and Audible Alarm 16
7.1.g Cell Indicator Lights 17
7.1.h Display Overview 17
7.2 Basic Operational Programming 17
7.2.a Adjusting the Purifier Output % 17
7.2.b Boost 17
7.2.c Purifier Mode 18
7.2.d Purifier % Adjustment Procedure 18
7.3 Review of Main Menu Programming 19
7.3.a Enable / Disable Audible Alarm 19
7.3.b Boost 19
7.3.c Set Reverse Time 20
7.3.d Force Reverse 20
7.3.e Replace a Cell 20
7.3.f Set Cell Power 20
7.3.g English/Metric (units) 20
7.3.h Set Temperature Unit 20
7.4 Review of Installer Menu Programming 21
7.4.a Calibrate Temperature 21
7.4.b Calibrate Salt 21
7.4.c Set Pool Volume 21
Section 8 - Installation
8.1 Basic System Overview 22
8.2 Planning the Installation 23
8.3 Installation Steps 23
8.4 Mounting the Control Center 23
8.5 Plumbing the System 24
8.5.a Plumbing the Manifold Assembly 24
8.5.b Plumbing for Convection Cell Applications 24
8.5.c Flow Rates 20 – 70 gpm (76 – 265 L/min) 25
8.6 Preparing the Pool Water 25
8.6.a Calculating Pool Volume 25
8.6.b Steps to Prepare Water 26
8.6.c Adding Salt 26
8.7 Programming at Installation 27
8.8 Electrical Connections 28
8.8.a AC Input Voltage 28
8.8.b Bonding 28
8.9 High Voltage Wiring 28
8.10 Low Voltage Wiring 29
8.10.a Tri-sensor Cord 29
8.10.b Cell Cord 29
8.11 ORP Connection 30
ii
To Next Page
Loading...
