7
Press this button can be used to set the feeling function. The LCD shows the actual
room temperature when the function set and it shows the setting temperature when the
function cancelled. This function is invalid when the appliance at the fan mode.
5.“STRONG”button
Only under the state of cooling or heating mode, press this button, the motor speed is
adjusted to strong auto-matically and the LCD displays "high fan" , the "strong"
function is started to reach the highest cooling or heating.
6.“TIMER”button
Setting the “ON” timer time：
a. When remote controller is at off state, press “T IMER” button, the LCD displays
“TIMER ON” and the timer time, the range of setting time is 0.5h to 24h.
b. You can press the “ ” or “ ” button to adjust the timer time, each touch will be
set time to increase or reduce 0.5h before 10 hours ago, after ten hours will be set time
to increase or reduce 1h per pressing, to enables your required timer.
c. Press “TIMER” button again, to set the timer on function.
d. You can set another function to insure the suitable state after air conditioner turn on
(including mode, temperature, swing, motor speed and etc). The LCD will displays
all your setting and keep it, when the timer reach to the set time, the air conditioner
will be working according to your set automatically.
Setting the “OFF” timer time：
a. When remote controller is at on state, press “TIMER” button, the LCD displays
“TIMER OFF” and the timer time, the range of setting time is 0.5h to 24h.
b. You can press the “ ” or “ ” button to adjust the timer time, each touch will be
set time to increase or reduce 0.5h before 10 hours ago, after ten hours will be set time
to increase or reduce 1h per pressing, to enables your required timer.
c. Press “TIMER” button again, to set the timer on function.
7.“TIMER”button
You can let the LCD display working or not by pressing this button.
8. “ ”or “ ”button
Press the “+”or “-“ button, you can set the temperature range from 16℃ to 32℃,
Display will change when you touch the button.
9.“CLEAN”button
a. When remote controller is at the off state, press "clean" button, the wind guiding
bars turn to initial positions for cooling, the A/C runs "clean" function with max
duration 35mins. The purpose of this function is to clean dust on evaporator and dry
the inside water of evaporator and to prevent the evaporator going moldy due to water
deposition and boasting strange smell.
b. After setting "clean" function, press "clean" button again to cancel “clean” function
or press ON/OFF" button to cancel “clean” function and start A/C.
c. The clean function will be stop working after 35 minutes running working without
any operation.
Note: “clean" function can be set in parallel with " time start " function; in this
case, "time start " function will be executed after "clean" function.
10.“MODE”button
To Next Page
Loading...
Need help?
General
