AUX L - Page 15

EN
⑩ "TIMER" button
This buttton is used to set the Timing On or the Timing Off function.
⑪ "SILENCE" button
Set silence on or off(the characters of silence will appear or disappear)by pressing this key.
Once energized, the unit will be defaulted to be silence off.
⑫ "TURBO" button
Set turbo on or off(the characters of turbo will appear or disappear)by pressing this key under
cooling or heating mode. Once energized, the unit will be defaulted to be turbo off. This function
can not be set under auto, dry or fan mode, and characters of turbo won't appear.
@ "DISPLAY" button
In display mode, press button once, switch off*DISPLAY'. Press *DISPLAY'again.LCD will show
ambient & setting temperature after flashing 5s. It's convenient for users to check ambient or
setting temperature at any time in darkness.
⑭ "iCLEAN"button
When remote controller is at the off state, press "iCLEAN" button, the unit runs "iCLEAN" function
The purpose of this function is to clean dust on evaporator and dry the inside water of evaporator
and to prevent the evaporator going moldy due to water deposition and boasting strange smell.
After setting "iCLEAN" function, press "iCLEAN" button or "ON/OFF" button to quit.
The clean function will stop working after about 30 minutes running without any operation
⑮ "ELE. H"button (for auxiliary electric heating IDU)
In heating mode, press this button, auxiliary electric heating will work.
⑯ "Anti-FUNGUS" button
The purpose of this function is to dry the inside of the evaporator and to prevent the evaporator
from going mouldy due to water deposition and thus dispersing strange smell.
To operate the function: under OFF status of the A/C and the remote controller, press
"Anti-FUNGUSMbutton for one time, the buzzer keep beeping five times again after five times beep,
indicating that this function is ready.
To cancel the function: 1. under "OFF "status of the A/C and the remote controller, press
nAnt1-FUNGUS" button again.
⑰ "SPOT SWING" button
Press this button, the horizontal wind direction vanes can swing automatically, when you have
the desired vertical wind direction.
Press "SPOT SWING" again, the horizontal wind direction vanes will be stopped depend on you.
4