EN
•Drying operation mode
1. Press the ON/OFF button, the air-conditioner starts to operate.
2. Press the MODE button, select the DRY operation mode.
3. Press the " A " o r" V " button, set the temperature, temperature can be set at 1°C difference
range from 16-32°C.
4. Press the SPEED button, you can select fan speed.You can select fan speed from LOW ^ID,
HIGH, AUTO.
5. Press ON/OFF button again, the air-conditioner stops.
Note:
This manual introduces function for all of the remote controller, maybe you press
one button without any reaction, well, the air-conditioner you bought has no this
function.
•Timer button mode
1) Clock Function
Clock setting during using period,the method just like below :
l.Open the lid of the remote controller,then press Timer button,the Clock function is activated.
2. Press the or “▽” button to set the clock time, The time is 12-hour system with
a.m.& p.m.
3. Press the TIMER button again to confirm the clock time.
2) Timing ON Function
Timer ON function must be set when the airconditioneris off.
The method just like below:
l.Open the lid of the remote controller,then press TIMER button, the letter "ON
•丨
will be
displayed and flicker.
2_Press the or u\ / v button to set the time, the time is 12-hour system with a.m.& p.m.
3. Press the TIMER button again to confirm the clock time.
4. Press other button to select the operation condition.(including mode .temperature, swing,fan
speed,etc.).
Note:
When the Clock or Timing on setting is the same asthe setting time, the air conditioner
will automaticlly close or operate .
• Fan operation mode
1. Press ON/OFF button, air-conditioner starts to operate.
2. Press MODE button, select Cooling or Heating operation mode.
3. Press SPEED button, you can select fan speed from LOW, MID, HIGH, AUTO.
4. Press ON/OFF button again, air-conditioner stops.
Remark: In the circulation operation mode, temperature setting can't work.
• Sleep operation mode
1 .Press ON/OFF button, the air conditioner starts to operate.
2. Press the MODE button to select cooling or heating status.
3. Open the lid of the wired controller, press the SLEEP button,the display will shows ,the sleeping
function will be activated.
6
To Next Page
Loading...
