Avanti GR2012CB - User Manual

52 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

INSTRUCTION MANUAL

MANUAL DE INSTRUCCIONES

20” WIDE

24” WIDE

Model Numbers / Nos. de Modelos:

GR2011CW

GR2414CW

GR2012CB

GR2415CB

GR2013CSS

GR2416CSS

GAS RANGE / COCINA DE GAS

BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING

INSTRUCTIONS. AND SAVE FOR LOCAL GAS AND ELECTRICAL INSPECTOR’S USE.

La sección en español empieza en la página 28

Avanti Products has a policy of continuous improvement on its products and reserves the right to change materials and

specifications without notice.

Avanti Products LLC

P.O. Box 520604 - Miami, Florida 33152

www.avantiproducts.com

Models:

GR2011CW / GR2012CB

GR2013CSS

Models:

GR2414CW / GR2415CB

Model:

GR2416CSS

Table of Contents

Other manuals for Avanti GR2012CB

Installation Instructions20 pages

Questions and Answers

D
Derek WhiteAug 13, 2025
What to do if surface burners do not light on my Avanti Ranges?
- D
  Debbie OchoaAug 13, 2025
  If the surface burners on your Avanti Ranges aren't lighting, several factors could be at play. First, ensure the surface control is fully turned to the ON position. Push it in and turn it until the burner ignites, then adjust to your desired flame. Also, check for clogged burner ports and use a small gauge wire or needle to clear them. Verify burners are correctly positioned on the orifice hoods, sitting flat on the burner support with tabs engaged in slots. Confirm the range is set for the correct gas input. Ensure the range power cord is plugged into a grounded outlet. If it is a power failure, light pilots manually.
K
kristinleeAug 16, 2025
Why is my Avanti Ranges oven or broiler not heating?
- E
  Edgar BowmanAug 16, 2025
  If your Avanti Ranges oven or broiler isn't heating, several things could be wrong. First, make sure the temperature control is set to the desired temperature. If there was a power failure, light the pilots manually. Check your house fuse or circuit breaker and replace the fuse if necessary, without increasing its capacity. If the range cord is disconnected, ensure it is plugged into a grounded outlet. Also, confirm that the range is set for the appropriate gas input.
L
Loretta SmithAug 20, 2025
Why is the flame orange on my Avanti GR2012CB Ranges?
- S
  sanchezdavidAug 20, 2025
  An orange flame on your Avanti Ranges usually indicates dust particles in the main line. Let the burner operate for a few minutes; the flame should turn blue. Also, check if the range is set for the appropriate gas input.
K
kellymorrisonAug 25, 2025
What to do if my Avanti GR2012CB Ranges oven temperature is inaccurate?
- A
  Amber RogersAug 25, 2025
  If your Avanti Ranges oven temperature is inaccurate, start by checking the oven capillary bulb. Make sure it's snapped straight in the clips and isn't touching the sides or coated with oven cleaner or food. Also, ensure the temperature control knob is set correctly. Avoid improper use of foil by keeping it clear of holes in the oven bottom and away from the oven sides. Finally, ensure that the vent on the backguard is clear.
Z
zcraneAug 28, 2025
What to do if my Avanti GR2012CB Ranges oven smokes excessively?
- T
  Tiffany WarrenAug 28, 2025
  If your Avanti Ranges oven is smoking excessively, it might be due to the meat being too close to the broiler burner. Reposition the broiler pan to increase the space between the meat and the burner. Also, remove excess fat from the meat before cooking.
J
Jeffrey BrownAug 31, 2025
How to fix an Avanti GR2012CB Ranges that is not level?
- M
  Madeline BennettAug 31, 2025
  To fix an Avanti Ranges that is not level, start by placing an oven rack in the center of the oven and put a level on the rack. Adjust the leveling legs accordingly. Ensure the floor is level and can support the range; contact a carpenter for sagging floors. Check that your kitchen cabinets are square and provide enough clearance for the range; contact a cabinet maker if needed.
P
Pamela SmithSep 4, 2025
Why is the flame burning halfway round on my Avanti GR2012CB?
- B
  Brian WoodsSep 4, 2025
  If the flame on your Avanti Ranges is only burning halfway around, it could be due to a few reasons. First, check for clogged burner ports and use a small gauge wire or needle to open them. If there's moisture present after cleaning, lightly fan the flame and let the burner run until the flame is full. Also, you can dry the burners thoroughly. Lastly, ensure that the range is set for the appropriate gas input.
A
Angela WatkinsSep 7, 2025
What to do if the oven light does not work in my Avanti GR2012CB Ranges?
- L
  Lori GreenSep 8, 2025
  If the oven light in your Avanti Ranges isn't working, try tightening or replacing the oven light bulb.

Avanti GR2012CB Specifications

General

Type	Freestanding
Fuel Type	Gas
Number of Burners	4
Color	Black
Width	20 in.
Ignition Type	Electronic
Material	Stainless Steel
Height	36 inches
BTU per Burner	9, 000

Related product manuals

Preview: Avanti GR2011CW

Avanti GR2011CW

Avanti GR2013CSS

Avanti GR2414CW

Avanti GR2416CSS

Preview: Avanti GRO20P0W

Avanti GRO20P0W

Avanti GRO24P0W

Preview: Avanti DG2450SS

Avanti DG2450SS

Preview: Avanti DGR20P3S

Avanti DGR20P3S

Preview: Avanti ER2003CB

Avanti ER2003CB

Avanti ERU240P0W

Preview: Avanti DER 202 BS

Avanti DER 202 BS

Avanti ELITE DG200W