T
Thomas MorganAug 13, 2025
What to do if surface burners do not light on my Avanti Ranges?
- ZzmillerAug 13, 2025
If the surface burners on your Avanti Ranges aren't lighting, several factors could be at play. First, ensure the surface control is fully turned to the ON position. Push it in and turn it until the burner ignites, then adjust to your desired flame. Also, check for clogged burner ports and use a small gauge wire or needle to clear them. Verify burners are correctly positioned on the orifice hoods, sitting flat on the burner support with tabs engaged in slots. Confirm the range is set for the correct gas input. Ensure the range power cord is plugged into a grounded outlet. If it is a power failure, light pilots manually.








