Avanzini DRAGO P1 User Manual (English)

Other manuals for Avanzini DRAGO P1

Instruction, Use And Maintenance Manual96 pages

Questions and Answers:

M
Michael PrattJul 25, 2025
Why is there soot on the Avanzini Burner cupola?
- A
  audreyjohnsonJul 25, 2025
  Soot on the cupola can be caused by several factors: * The burner's air/gas ratio might not be properly adjusted, resulting in insufficient air. * The environment may lack proper ventilation. * The chimney could be dirty or closed. * The burner might be under the oven without enough oxygen. * Inadequate cleaning of the flue after converting from a wood-burning oven could be the reason. * Spacer washers might be missing between the burner and the flange sleeve. * The burner compartment may have a special opening. * Suction in the room requires sizing the air intake to account for both the air burned by the burner and the air extracted.
D
Dr. Emily HardingJul 30, 2025
What to do if Avanzini DRAGO P1 heats slower than normal?
- R
  Rhonda StokesJul 30, 2025
  If your Avanzini burner is heating slower than normal, check the following: 1. Ensure the burner is delivering the correct kilocalories by observing the flame, it should reach at least the center of the cupola. Adjust the flame using the adjustment screw on the valve if needed. 2. Verify that your plant, meter, and pipe cross-section are appropriately sized for the length. 3. Confirm there are no pressure drops when other appliances like hobs, deep fryers, hot water and heating boilers, and kitchen ovens are started.
D
davidleblancAug 4, 2025
What to do if the Avanzini Burner flame is too high?
- E
  erica96Aug 4, 2025
  If the flame in your Avanzini burner's baking chamber is too high, causing pizza toppings to burn or extending beyond the center of the cupola, slowly adjust the flame height to approximately reach the center of the cupola.
A
Angela TuckerAug 9, 2025
What to do if the Avanzini Burner spark strikes but the flame does not ignite?
- H
  hawkinsmarissaAug 9, 2025
  If the spark strikes but the flame does not ignite on your Avanzini burner, consider these checks: * Ensure all gas system valves between the burner and counter are open, including the safety solenoid valves. * Disassemble the burner and clean it by turning it over and blowing compressed air from the air intake and flame breaker. * Check that the white power cable is intact. * Verify the integrity and correct positioning of the ignition electrode; replace it if cracked. * If needed, replace the pilot flame assembly.
K
knoxderekAug 15, 2025
How to fix Avanzini DRAGO P1 Burner if pilot flame does not stay on?
- K
  Kristin LopezAug 15, 2025
  If the pilot flame does not remain on for your Avanzini burner, try the following: * Purge the copper pipe that brings the gas to the pilot flame. * Check the integrity of the thermocouple and replace it if necessary. * Ensure that the thermocouple connections are tight.
S
Sean VegaAug 19, 2025
How to troubleshoot Avanzini DRAGO P1 Burner when it doesn't start?
- W
  William BakerAug 19, 2025
  If your Avanzini burner does not start when the start button is pressed and the spark does not strike, the issue might be: * Flat batteries under the start button. Replace the batteries. * The spark dispersing along the path of the white wire. Ensure the spark does not disperse along the path of the white wire.