Table 16: 1000BASE-EX DDI SFP transceiver specifications
Parameter Specification
Maximum electrical power consumption 1.2 W
Connectors Duplex LC
Cabling SMF, 9 μm
Data rate 1.0 Gbps
Line rate (8B/10B code) 1.25 Gbps
Link optical power budget 30 dB
Maximum dispersion power penalty 2.0 dB at 120 km
Minimum attenuation between transmit and receive
ports
14 dB
Transmitter characteristics
Launch power 0 to 5.0 dBm
Receiver characteristics
Receiver sensitivity –30 dBm
Maximum receiver power –9.0 dBm
1000BASE DDI CWDM 70 km SFP specifications
The 1000BASE SFP transceiver provides CWDM gigabit Ethernet connectivity using single mode
fiber. This SFP transceiver supports only full-duplex operation.
Important:
For the 70 km CWDM SFP transceiver, a minimum attenuation of 10 dB must exist between the
transmitter and receiver.
The following table describes specifications for CWDM SFP transceivers numbered AA1419061-E6
to AA1419068-E6.
Warning:
Risk of equipment damage
To prevent damage to the optical receiver, ensure that at least 8 dB of attenuation exists
between the transmit and receive ports.
Table 17: 1000BASE-ZX CWDM SFP DDI (70 km) specifications
Parameter Specifications
Maximum electrical power consumption 1.0 W
Connectors Duplex LC
Cabling SMF, 9 µm
Data rate 1.0 Gbps
Table continues…
SFP
34 Installing Transceivers and Optical Components on Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
