Avaya ERS 3500 Series - Installing an SFP+

Job aid
SFP+ transceivers are hot-swappable input and output enhancement components that allow 10-
gigabit connections.
All Avaya SFP+ transceivers use LC connectors to provide precision keying and low interface
losses.
The following table lists and describes the Avaya SFP+ models.
Model ROHS product number Description
10GBASE-SR/SW SFP+ AA1403015-E6 400 m, 850 nm MMF
10GBASE-LRM SFP+ AA1403017-E6 220 m, 1260 to 1355 nm; 1310 nm
nominal MMF
10GBASE-LR/LW SFP+ AA1403011-E6 10 km, 1310 nm SMF
10GBASE-ER/EW SFP+ AA1403013-E6 40 km, 1550 nm SMF
10GBASE-CX SFP+ 2-pair
twinaxial copper cable that plugs
into the SFP+ socket and
connects two 10-gigabit ports
AA1403018-E6 10 meter
AA1403019-E6 3 meter
AA1403020-E6 5 meter
10GBASE-ZR/ZW SFP+ AA1403016-E6 70 km, 1550 nm SMF
10GBASE-ER CWDM DDI SFP+ AA1403153-E6 to AA1403160-E6 40 km, 1471 to 1611 nm
10GBASE-ZR CWDM DDI SFP+ AA1403161-E6 to AA1403168-E6 70 km, 1471 to 1611 nm
Installing an SFP+
Install an SFP+ transceiver to provide a 10-gigabit Ethernet interface between the device and other
network devices.
Before you begin
Important:
Do not install an SFP+ transceiver in an SFP slot. The two transceivers look the same but
function differently. Ensure the slot is an SFP+ slot.
• Verify that the SFP+ transceiver is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Danger:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber optic cables connect to a light
source.
SFP+ transceivers
July 2015 Installing Transceivers and Optical Components on Avaya ERS 3500 Series 37
Comments on this document? infodev@avaya.com