Avaya NEC NEAX 2400 IMS - Page 4

NEC 2400 Confidential
The information contained in this document is provided by AVAYA Inc. to serve as a guide. See the disclaimer on page 1
4
The settings for SW01 should be as follows: Settings 1, 2, and 3 set to
off, on, off for a baud rate of 9600 BPS. Setting 4 is set to on for
Parity Bit valid. Setting 5 is set to on for odd parity. Setting 6 is set to
on for 7 bits. Setting 7 is set to off for 2 stop bits. Setting 8 is set to on
for Send Side FIFO is 1 byte. See Figure 2.
12345678
SW01 off on off on on on off on
Figure 2.
NOTE: If using Port 2 on the I/O-02 card, configure the settings on SW11
the same as above.
The settings for SW02 or SW12 should be as follows: Setting 1 is set
to on for PB signal not provided. Setting 2 is set to on for DTR.
Setting 3 is set to off for DSR is provided. Setting 4 is set to off for
CD is provided. Settings 5, 6, and 7 are set to on for CS, CI, and PB
not provided. Setting 8 is not used. See Figure 3.
12345678
SW02 on on off off on on on off
Figure 3.
NOTE: If using Port 2 on the I/O-02 card, configure the settings on SW12
the same as above.
o Verify that all four settings on SW13 are off. The card is now
configured for RS-232 operation.
NOTE: If the PBX is taken out of service and restarted, the MCI port
might not operate. If this is the case, unplug the RS-232 link from the
Octel voice module, then have the PBX vendor reset the system
processor.
5.1 CONFIGURING THE VOICE LINES
o Assign single-line ports for the Octel system in the ASDT (Assign
Station Data Table) with TEC=3.
o Assign a Service Feature Class (SFC) to those ports. Within the
SFC, disable the Distinctive Ringing feature for all ports. This is
accomplished with ASFC Index 48. If this feature is enabled,
problems with integration occur.
o Assign the Octel voice ports to a UCD group using the ASHU
command.
The pilot number of the above UCD group is the Octel voice module
Access Number. It is used by subscribers to call the Octel voice
module to retrieve their messages. It is also used by subscribers to
forward their phones to the Octel voice module.
Configuring the single-line ports
for the Octel System