1. Place the sticker on the wall surface. Then
spot the mark and drill the 5 holes indicated
on the sticker. If you are going to run the wire
through the lateral side, it’s not necessary to
drill through the big hole.
2. Insert the 4 plastic anchors in the wall.
3. Hook the IP Camera and place the washer on
the 4 screws. Use the hex socket cap bolt to
secure the IP camera.
4. After adjusting the focus and zoom control,
use the L-type wrench to secure the case of
IP camera from being tampered.
To Next Page
Loading...
Need help?
General
