AVer PAPTZ330N - Remote Controller

10
Remote Controller
(1)
(2)
(3)
(4)
(6) (7)
(5)
(9)
(11)
(17)
(8)
(10)
(12)
(14)
(15)
(16)
(13)
BLC
Menu
Name
Function
(1) Power
Turn the unit on/standby.
(2) Camera Select
Select 1~4 PTZ camera.
Set the camera ID in OSD menu: System > Camera Selector, ex:
camera ID is set to 1. Then, press the “camera select” button “1” to
control the camera.
(3) Numeric Pad
 Use for setting the preset position 0~9.
 Press number button (0~9) to move the camera to pre-configure
preset position 0~9.
(4) Preset
Press “Preset” + “Number button (0~9)” to set the preset position.
(5) Reset
Press “Reset” + “Number button (0~9)” to cancel the pre-configure
preset position.
(6) BLC
Turn on/off backlight compensation
(7) Menu
Open and exit the OSD menu.
(8)
▲,▼,◄, & ►
Pan and tilt the camera lens.
(9)
- Confirm the selection or make a selection in OSD menu.
- One push focus.
(10) L/R DIR
Left and right orientation setting.
- Press “L/R DIR” + “#1” button to reset setting.
- Press “L/R DIR” + “#2” button to move to opposite direction.