28
Preset Setting
Setup preset position and view preset position.
1. Select the “Preset” tab in live view interface.
2. Use , , , and to adjust camera view position.
3. Enter preset position number (0~255) in
Save Preset
column and select “
Save
” to save the
position.
4. To call the preset position, enter a preset number (0~255) in
Load Preset
column or select the
preset number (0~19) from
Quick Call
section.(Recalling preset will disable auto tracking)
5.
Video Freeze with Preset:
On/Off the screen view freeze function. When “
Video Freeze with
Preset
” is on, during the preset operation, the screen will freeze until the operation is done.
Tracking Control
Enable/disable tracking function, select tracking mode, and operate one-click tracking function.
Tracking mode(Tracking mode setup refer to Tracking Settings section)
Presenter: Camera will start tracking when object enter the tracking point (preset point) and
the face of object is detected.
Zone: Camera will start tracking when object is moving between the preset tracking block
area.
Hybrid: Mix the Presenter mode and Zone mode together.
To Next Page
Loading...
Need help?
General
