AVer VC520 Pro2 - Operating the Camera; Make a Video Call; Make a Connection through the Browser

21
Operating the Camera
Make a Video Call
1. Make sure all devices (VC520 Pro2, speakerphone and PC/laptop) are well connected and power
is on.
2. Run your video application (Zoom, Microsoft
®
Teams, Skype for Business, Skype, Google Meet,
Intel
®
Unite™, RingCentral, BlueJeans, V-Cube, LiveOn, CyberLink U Meeting
®
, TrueConf,
Adobe Connect, Cisco WebEx
®
, Fuze, GoToMeeting™, Microsoft
®
Lync™, Vidyo, vMix, WebRTC,
Wirecast, XSplit, etc.) on your PC or laptop.
3. Set the VC520 Pro2 camera and speakerphone as the primary camera and speakerphone for
your video application (refer to your video application user guide). You can now make your call.
[Note] The VC520 Pro2 is a plug-and-play conference camera. The system requires no special drivers,
but we do recommend installing the PTZApp 2 for a better user experience. For information on how to
install and use the PTZApp 2, refer to the PTZApp 2 section in this user manual.
Make a Connection through the Browser
VC520 Pro2 has an Ethernet port for IP streaming and allows administrators to remotely control and
set up the camera via an internet access. Moreover, VC520 Pro2 also supports RTSP and RTMP
functions. For more details, please contact our technical support.
1. Make sure the VC520 Pro2 has an internet access connection.
2. Launch PTZApp 2* ( ) and connect VC520 Pro2 to PC with USB cable. The camera default IP
address is 192.168.1.168.
[Note] The browser supports:
 Chrome: version 76.x or above  Firefox: version 69 or above  IE: Doesn’t support