AVer VC520 Pro3 - Camera Control Options; Camera Binding and Saving Presets

27
Camera Focus
Set auto/manual focus
mode.
 Manual: Select to switch the focus to manual
adjustments. Drag the slider below to adjust
the focus value.
 Auto: Select to switch the focus to automatic
adjustment.
Home Position
Set the camera initial
home position when you
power it on.
 Last Operation Position: Select to switch the
initial home position to the last operation
position before you power the camera off.
 Factory Center Position: Select to switch the
initial home position to the factory setting
position (facing toward).
 Preset 0: Select to switch the initial home
position to Preset 0.
Sleep Position
Set the camera position
when it is idle for a certain
period (configurable sleep
timer) and go to the sleep
mode.
 Factory Downside Position: Select to switch
the sleep position to the factory setting position
(facing down).
 Preset 9: Select to switch the sleep position to
Preset 9.
Sleep Timer
Set the camera idle time to
enter sleep mode.
[Notes] The camera won’t
enter sleep mode during
USB Streaming or
RTSP/RTMP Streaming.
 Off
 10 sec
 5 min
 10 min
 20 min
On Screen Menu
Enable or disable on-
screen status information.
 Off: Stop showing all on-screen status info
when operating the camera.
 On: Show all on-screen status info when
operating the camera.
 Load Preset Off: Only stop showing the
on-screen info when loading presets.
Camera Binding
Select a camera to
operate. Specify a number
in the setting to connect.
 Off
 Camera1
 Camera2

Camera3
Save Preset
Enable or disable this
function. When off, you
can’t save preset points
via IR remote, Hot key,
VISCA, and webpage.
 Off
 On