AVer VC520 User Manual

9
Use VC520
Make a Video Call
1. Make sure all devices (camera, hub, speakerphone, and laptop/PC) are well connected and hub is
powered on.
2. Run your video application (Skype
TM
, Microsoft
®
Lync
TM
, Google Hangout, Cisco WebEx
®
,
GoToMeeting
TM
, WebRTC, and etc.) on your laptop or PC.
3. Set the VC520 camera as the primary camera for your video application (refer to your video
application user guide). You can now make your call.
4. The VC520 is a plug-and-play conference camera. The system requires no special drivers, but we do
recommend installing the AVer PTZApp for a better user experience. For information on how to install
and use the AVer PTZApp, refer to the AVer PTZApp section in this user manual.
Phone in
To connect the VC520 speakerphone to your mobile phone as a hands free call device.
1. Use the included 3.5mm AUX cable to connect your mobile device to the “Phone In” jack on the
speakerphone.
2. Once the VC520 detects the proper connection to your mobile phone, When connection is successful,
the “Cellphone” indicator will light up.
Line in
To connect another VC520 speakerphone to extend the distance of speakerphone coverage to cover a
room that has a diameter larger than 30’ and increase the volume:
1. Connect one side of the daisy chain cable (not included) to the speakerphone port (daisy chain).
2. Connect the other side of the cable to the speakerphone port on the other VC520 speakerphone.
LED Indicator
 Camera
Status
LED
Starting
Flashing blue and camera head is rotating
Normal
Solid blue
Camera is not being used
by the computer
Solid orange
Camera is not connected
Solid orange and camera head is down.

AVer VC520 Specifications

General

Zoom	12X optical zoom
Speakerphone	Yes
Echo Cancellation	Yes
Noise Reduction	Yes
Resolution	1920x1080
Video Compression	H.264
Video Resolution	1080p (1920x1080)