example certain laptop configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and
the FCC ID can not be used on the final product.
End Product Labeling
The final end product must be labeled in a visible area with the FCC ID.
Modifications
The FCC requires the user to be notified that any changes or modifications
made to this device that are not expressly approved by the Manufacture
may void the user’s authority to operate the equipment.
Connections to Peripheral Devices
Connections to this device must be made with shielded cables with metallic
RFI/EMI connector hoods to maintain compliance with FCC Rules and
Regulations.
Declaration of Conformity
This device complies with Part 15( CLASS B)/68 the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
European Notice
Products with the CE Marking comply with both the EMC Directive
(89/336/EEC) and the Low Voltage Directive (73/23/EEC) and R&TTE
Directive (1999/5/EC) issued by the Commission of the European
Community.
Compliance with these directives implies conformity to the following
European Norms:
n EN55022 : 1998+A1: 2000+A2: 2003, CLASS B
n EN61000-3-2 : 2000
n EN61000-3-3 : 1995+A1: 2001
n EN55024 : 1998+A1 : 2001+A1: 2003
n IEC61000-4-2: 2001
n IEC61000-4-3:2002+A1:2002
n IEC61000-4-4:1995+A1:2000+A2:2001
n IEC61000-4-5:2001
n IEC61000-4-6:2001
n IEC61000-4-8:2001
To Next Page
Loading...