Avery Dennison AP 5.4 - Max. Print Length; Zero Line; Fonts; Modifying Fonts

01/11 Rev. 5.05-09 USER / SERVICE MANUAL Technical Data
AP5.4 – AP5.6
4
[2] Measures and setting range of the punch / reflex mark.
Max. print length
The maximum print length depends on the following:
• Printer type
• Printer resolution
• Firmware version
• Parameter settings regarding memory allocation (e.g. SYSTEM
PARAMETERS > Free store size)
Zero line
Offset of the material zero line to the print zero line: 1mm (what means that a
stripe of 1mm width at the inner label margin is unprintable)
Fonts
• 17 Fixsize fonts , including OCR-A and OCR-B
• 3 scalable fonts (Speedo fonts)
• Truetype fonts are supported
• Optionally can Truetype, Speedo and Fixsize fonts be stored on SD-card
Modifying Fonts
• Up to factor 8 scaling in x/y direction
• Rotation by 0, 90, 180 and 270 degrees
Impression accuracy
[3] The impression accuracy depends on the print position on the label: the longer the distance to the gap
is, the lower is the impression accuracy. The maximum impression accuracy is at the gap position with
+/- 1mm.
Reading examples:
A: Print positioin 1 is located 50mm behind the gap position. The maximum
possible deflection from the theoretical print position is +/- 1.5mm.
B: Print positioin 1 is located 250mm behind the gap position. The maximum
possible deflection from the theoretical print position is +/- 3.5mm.
 Those values are empirical for typical applications with common label stock
/ foil combinations. Since the deflection of the print position strongly depends
on the applied label stock / foil combination, it can turn out higher if unfavorable
combinations are used.
a
b
c
Z0211.cdr
A
A
B
B