AVG AVP286PPS - Troubleshooting

29
steel to prevent any unattractive crisscross scratching patterns.
IMPORTANT
When cleaning only use mild detergents. Avoid using harsh cleaning chemicals, strong household detergents
or abrasive products, as they will affect the appliance appearance and potentially remove any printing of
artwork on the control panel. Failure to follow these instructions will void the warranty.
GREASE FILTERS (micro-holes & baffle)
The filters should be hand-wash as they are not dishwasher safe. Soak them for about 3 minutes in water with
a grease-loosening detergent then scrub gently with a soft brush. Do not apply too much pressure, to avoid
any damage. Filters should be washed separately from kitchen utensils. Do not to use any kind of rinse aid.
6.TROUBLESHOOTING
Fault
Possible Cause
Solution
Light on, but motor does
not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not work,
motor does not work
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet. Switch
power outlet on.
Oil leakage
Examine valve /outlet verify that are
tightly sealed
Take down the check valve and seal
with sealant.
Leakage from exhaust duct and cover
Take exhaust duct down and seal.
Lights not working
Broken/Faulty LED lamps
Replace LED lamps as per instructions.
Insufficient suction
The distance between the range
hood and the cooking surface is too
high
Reinstall the range hood to the correct
distance.
The range hood is
leaning
The fixing screws are not tight
enough
Tighten the hanging screws and level
the hood correctly.
IMPORTANT: Any electrical repairs made to this appliance must conform to your local,
provincial and federal laws. Please contact the service center before undertaking any repairs.
Always disconnect the unit from the power source before servicing or maintaining.