Cleaning&Inspection
STEP 1: CLEANING
Clean all metal parts in solvent, including the
cable anchor bolt and plate, and for TYPE F
brakes, the separate cable housing ferrule. Clean
the cable seal boots, outer caliper body seal, and
inner body seal in mild soap and water.
Rinse and dry all parts completely.
STEP 2: CALIPER BODY INSPECTION
Inspect the caliper body for any damage, paying
special attention to all threaded surfaces and the
pad retainer clip in the top of the caliper body.
Lockring
Threads
Inner Pressure
Foot Threads
Pad Retainer
Clip
9
To Next Page
