Eleven Rack User Guide10
Edit/Back and Save Buttons
Use the Edit/Back button to enter Rig View,
which gives you access to the inner workings of
the current Rig (preset). When in Rig View or
any other non-default view, you can Press
Edit/Back to step backwards to the previous
view. When you’re satisfied with the changes
you’ve made, press the Save button to save your
settings.
User Options Mode
Hold the Edit/Back button to enter User Options
mode, where many settings that change the be-
havior and configuration of Eleven Rack can be
found.
SW1 and SW2 Buttons
Use the SW1 and SW2 buttons to toggle various
switched behaviors on and off, and to navigate
through editing views in Eleven Rack. The part
of the display next to the SW1 and SW2 buttons
shows the current function of the buttons.
When one of the SW buttons are actively usable
in the current screen, it will be lit.
Scroll Wheel
Use the Scroll wheel to browse through Rigs,
navigate through sections in Rig View, and ma-
nipulate applicable parameters throughout
Eleven Rack.
Effects Control Buttons
Use the Effects Control buttons to toggle effects
on and off by type. Press and hold any of the ef-
fects buttons to access the controls for that ef-
fect. Pressing the FX1 and FX2 buttons simulta-
neously toggles the Wah effect on and off.
Tap Tempo/Tuner Button
Tap the Tap Tempo/Tuner button at quarter-
note intervals to set the current Rig’s FX tempo.
Time-based effects (such as Delay and Tremolo)
can be set to synchronize with the new tempo.
Most Rigs are not set up to sync to Rig or Session
tempo by default. You may need to turn on the
Sync parameter in the effect you want to sync.
If you want to save the new tempo setting with
the current Rig, press the Save button.
To access the built-in guitar tuner, hold the Tap
Tempo/Tuner button down for one second. The
display shows the Tuner view.
The guitar signal can be muted by pressing SW1.
The reference pitch can be adjusted by turning
the lit Control knob. The default reference pitch
is A-440 Hz. This pitch is the standard reference
pitch that most tuners are calibrated to.
When you’re finished tuning, press any button
to return to the previous screen.
For more information on Rig View, see
Chapter 3, “Exploring Rigs.”
For information on User Options mode, see
Chapter 8, “User Options.”
For more information on syncing effects, see
“Sync” on page 49.
Tuner view
To Next Page
Loading...
Need help?
General