12
To connect power to the camera, complete the following steps:
Remove the terminal block from the camera.
Remove the insulation from ¼” (6 mm) of the power wires. Be careful not to nick or dam-
age the wire.
Using a small slotted (5/64” or 2 mm blade width) screwdriver to loosen and tighten the
terminals, insert the two power wires into the two terminals. The connection can be made
with either polarity.
Plug the terminal block back into the receptacle ( ) on the rear of the camera.
Warning – This product is intended to be supplied by a UL Listed Power Unit marked
“Class 2” or “LPS” or “Limited Power Source” with output rated between 12-24 VDC
or 24 VAC, 9 W min. or Power over Ethernet (PoE), rated 48 VDC, 9 W min.
Table: Maximum power wire run length for different wire gauges.
Wire Gauge Maximum Run Length (ft [m])
AWG mm
2
24 VAC 12 VDC
24 0.2 131 [40] 29 [8]
22 0.33 214 [65] 47 [14]
20 0.5 342 [104] 76 [23]
18 0.82 545 [166] 121 [36]
16 1.3 857 [261] 190 [58]
1.
2.
3.
4.
To Next Page
Loading...
