14
Table: Connection States of Connection Status LED
Connection State Connection Status LED Description
No Link Off Usually indicates that the
camera is not physically
connected to another
network device
Obtaining IP
Address
One short flash every second The camera is attempting to
obtain an IP address
Connecting to NVR Two short flashes every second The camera has obtained
an IP address and is
attempting to connect to the
NVR
Upgrading
Firmware
Two short flashes and one long flash
every second
The camera is updating it’s
firmware
Connected On The camera is connected to
the NVR
IP Address Selection
The camera automatically obtains an IP address. Once connected to a network, the camera
will attempt to locate and obtain an IP address from a DHCP server. If this fails, the camera
will use Zeroconf (APIPA) to choose an IP address.
When the camera’s IP address is set using Zeroconf, its IP address is in the 169.254.* sub-
net.
The camera can be set to a static IP address from the Avigilon Control Center software. Con-
sult the software user guide for details.
To Next Page
Loading...
