- 32 -
- Ping Setting Page :
There are 3 sections of the setting area :
1. Setting Rule Numbers :
User can click to select different rules numbers at the right side button “ Rule No: X “ as
following pictures . There are 29 rules available.
2. Ping Base Setting :
⚫ Ping Interval : The number of seconds ( Sec. ) between each ping .
⚫ Respond Time Out : The number of milliseconds (= ms.) of the device will wait for a
response from the Pinged device if no ping is detected within this time it will be considered a
Ping failure.
⚫ Ping After Action Delay : After ping finished , do the action after setting seconds ( Sec. )
⚫ Action Max. repeat times： Set the times to execute the Ping Failure action
Set 0 means action non stop - Keep action & no limit times.
To Next Page