AVIRE DCP - ADVANCED DCP PROGRAMMING VIA SMS; SMS Commands for Parameter Management; Dual SIM Card Parameter Settings (P051)

12
ADDITIONAL INFORMATION FOR PROGRAMMING THE DCP
SMS COMMANDS
+ All DCP parameters can be remotely congured via SMS sent to the SIM card’s number.
+ Each SMS message should begin with ‘Pin1234’ which is the access code to read or make any changes to the
conguration of the DCP.
+ You can modify or check several parameters in each SMS by separating them with commas ","
To send parameter information:
Text Description
Pin1234, Pzzz xxx (send) • Pin1234 is default PIN code for DCP
• Pzzz is the programming command
• xxx is the parameter
To read parameter information:
Text Description
PinXXXX, Pzzz? (send) • Pin1234 is default PIN code for DCP
• Pzzz is the programming command
• “?” is to request a parameter read
Note: Use a question mark ‘?’ when you are reading parameters.
Examples:
1. To program telephone number 1 in the DCP when connected to a DAU
E.g: Pin1234, P031 0123456789 (send, text message will come back with P031=0123456789)
2. To retrieve telephone number 1 in the DCP when connected to a DAU
E.g: Pin1234, P031? (send, text message will come back with P031= or with the programmed number)
CMD Description Default value
P005 CCID- Unique Identier of the Sim Card (19 digits)
P020
DCP Background Call Mode
P020=00 -> Transparent Protocol
P020=06 -> CAN Protocol
P020=21 -> P100 Protocol
21 (Autodialler’s need to make
Background calls in P100
Protocol)
P064 Background Call Periodicity (in Minutes) 4320 (3 days)
P030 Maintenance Alarm Number (Blank)
P031 Alarm Number 1
(Blank – Insert your alarm
number here)
P032 Alarm Number 2 (Blank)
P033 Alarm Number 3 (Blank)
P034 Alarm Number 4 (Blank)
P035 Background Number (not used with DAU)
3308084431 (must match
Background Number in
Autodialler, without prexes)
P008 Enable Guidance Message * 0 (disabled)
P085 Language 4 (English)
P091 Super settings set up 000
P003 DCP information (software version, type of DCP) As per package
P051 Dual SIM settings 0
Important Note: The default PIN code for DCP is always 1234.
Parameter P051 - Dual SIM card version:
0 SIM0 acting as a primary SIM card. In case of failure of primary SIM, it will switch to SIM1.
1 SIM1 acting as a primary SIM card. In case of failure of primary SIM, it will switch to SIM0.
2
SIM0 - Voice SIM, SIM1 - Data SIM. SIM1 is attahed to network, listening to any incoming calls, once an alarm call
is active, the DCP will switch to SIM0 and stay active till the end of alarm.