What to do if there is no live video on my Avtech AVC796?
If you're not getting any live video on your Avtech DVR, try the following: * Make sure the camera is receiving power. * Check the camera lens settings. * Inspect the monitor's video cable and connection. * Verify the camera's video cable and connection.
How to troubleshoot no power on my Avtech DVR?
If your Avtech DVR has no power, check the power cord connection and confirm that the outlet is supplying power.
Why is there no recorded video on my Avtech AVC796 DVR?
If your Avtech DVR isn't recording video, verify that the HDD is properly installed and connected. Also, ensure that both “MANUAL RECORD ENABLE” and the record function in the “CAMERA” menu are set to “ON”.
How to fix not viewing Avtech AVC796 images over the network with IE?
If you're unable to view DVR images over the network using Internet Explorer, check the DVR firmware version. Also, allow the web browser ActiveX or applet in the pop-out message.
What to do if HDD detection failed on Avtech DVR?
If your Avtech DVR fails to detect the HDD, try replacing it with another HDD for testing. You can also try replacing the HDD cable for testing purposes.
Why is motion detection recording not working on my Avtech DVR?
If motion detection recording isn't working on your Avtech DVR, make sure that the “EVENT RECORD ENABLE” option is set to “ON.” Also, verify that the detection function “DET” is set to “ON” and that the detection area “AREA” has been set up.
What to do if Avtech AVC796 DVR can’t detect USB flash drive?
If your Avtech DVR can't detect your USB flash drive, try replacing it with another USB flash drive for testing. Also, format the USB flash drive as FAT 32 format and try again.
How to fix failed firmware upgrade on Avtech DVR?
If you're experiencing a failed firmware/OSD file upgrade on your Avtech DVR, check that the USB flash drive is formatted to FAT32 and that the firmware/OSD file is correct.
What to do if Avtech AVC796 DVR is not working when pressing any button?
If your Avtech DVR doesn't respond when you press any button, it might be in “Key Lock” mode. Press any key and enter the password to exit this mode.
Why is timer recording not working on my Avtech DVR?
If timer recording isn't working on your Avtech DVR, check if the “TIMER RECORD ENABLE” option is set to “ON” and the timer schedule has been arranged.
Describes LED indicators and operational buttons on the DVR's front panel.
Details the various ports and connectors on the rear of the DVR unit.
Provides step-by-step instructions for installing a SATA hard disk drive into the DVR.
Explains how to connect normal and PTZ cameras, including video and optional audio inputs.
Guides on setting up instant event notifications to mobile devices via Push Video.
Covers quick and detailed record settings, including manual, event, and timer recording.
Explains motion detection settings like sensitivity, area, and motion activation.
Details network configuration options like STATIC, PPPOE, DHCP, and DDNS.
Explains how to view DVR images and operate it using a web browser.
General| Mobile Surveillance | Yes |
|---|---|
| PTZ Control | Yes |
| Backup Method | USB, Network |
| Compression | H.264 |
| Power Supply | DC 12V |
| Video Output | HDMI, VGA |
| Recording Frame Rate | 30 IPS @ 960H / D1 / CIF |
| Audio Input/Output | 1 channel |
| Hard Drive Support | SATA |
| Network Interface | RJ45 10/100Mbps |
| Channels | 16 |
| USB | 2.0 |
| Video Input | 4/8/16 channels |
To Next Page
