If no signal input in HDMI,TV, AV, SCART, YPBPR the screen will show a similar signal
to the following figure.
NOTE
HDMI, AV ,SCART and YPBPR SETUP
17
AV
NO SIGNAL
4:50
VIDEO SETTING MENU
This unit will go into standby mode automatically
with no signal input after 5 minutes.
The menu setup of HDMI/AV/SCART /YPBPR modes is much the same as that of TV
mode, except the " " section is invalid and a bit difference in sound mode. It is not
repeated here. You can find it in preceding pages.
If the input source is SCART, this unit will automatically recognise its RGB and CVBS
signal. If RGB is recognised, it will auto switch into RGB mode, or else it will work at
CVBS mode. The relative information will be automatically displayed on the right upper
of the screen .
To Next Page
Loading...
