RADIO OPERATION
E-6
AUTOMATIC TUNI
NG
MANUAL TUNING
It is for selecting stations, which cannot be tuned automatically. (manual selection)
To tune a channel manually.
- Skip step 4 in the above procedures.
- In step 3, each time the “SKIP +” or “SKIP -” button is pressed momentarily (0.5 second or less),
the frequency changes by a fixed step:
FM: 0.05 MHz steps
AM: 9 kHz steps
1. Press the “FUNCTION” button to select “TUNER” mo
de.
2. Press the “STOP / BAND” button to select AM or FM.
3. Press the “SKIP +” or “SKIP -” button to start automatic tuning process.
4. When a station is tuned in the tuning process, it will stop automatically and you can listen to your
desired station.
MEMORY PRESET
1. Repeat step 1 to 4 in the AUTOMATIC TUNING procedures.
2. Press the “PROGRAM” button to start the preset process.
3. Display will show the memory sequence number and a flashing “1”.
4. Press the “P - UP” or “P - DOWN” button or the “PROGRAM” button of front panel to determine
the preset station number.
5. Press again the “PROGRAM” button to preset your desired station.
6. Once all the stations were preset, press the “P - UP” or “P-DOWN” button to listen to your
desired station.
MONO / STEREO
Press the “BIT RATE” button to achieve the best frequency.
To Next Page
Loading...
