26
(wiring) should not be loose or damaged. pair
Control unit
(housing)
Visual
Control unit housing should be free of cracks
and opposing surfaces should seal tightly
without any gaps.
Replace
Control unit
(labels)
Visual Labels should be legible. Replace
Control unit
(cable)
Visual,
Electrical
continuity
Cable surface should be free of nicks, gouges
and abrasions. Each conductor on the cable
should have 100% electrical continuity, even
when the cable is flexed back and forth. Strain
relief element of the control unit cable should
sustain the entire weight of control unit, so
that no stress or weight will be applied on the
cable.
Replace
Warning la-
bels
Visual
Warning labels should be affixed on the hoist
and they should be legible.
Replace
Capacity la-
bel
Visual
Capacity label should be affixed on the hoist
and it should be legible.
Replace
MAINTENANCE
NOTE! Prior to doing any maintenance work, always switch off the appliance, un-
load it and pull out the mains plug. Repairs must only be carried out by an author-
ized service centre using original spare parts.
Replacing the wire
- Never use wire with different size or material from the original wire.
- If the hoist is loaded much and with heavy loadings, it may be necessary to replace the
wire more often than in normal use.
- if you detect any abrasion, broken strands, rust or other damage in the wire, replace it
immediately with a new one.
Lubrication
All the moving parts of the hoist have been permanently lubricated in assembly. In normal
conditions, this pre-lubrication performed in the factory is sufficient. However, if additional
lubrication is required after repair or dismantle, use grease suitable for boat usage for lubri-
cation.
Inspection schedule
- Inspections of the hoist may only be carried out by a responsible person who is familiar
with its operation. Repairs must only be carried out by an authorized service centre using
original spare parts.
- Maintain the appliance once a year or more often depending on the frequency of use.
To Next Page
Loading...