AWS H-110 - Troubleshooting; Error Codes

H-110
3. PressON/OFFagain.Thedisplaywillashthe
required calibration weight.
4. Place the weight on the end of the hook and press
ON/OFF when the weight is stable.
5. The display will show PASS and return to normal
weighing. If EEEE is displayed, try calibration again.
X. Troubleshooting
• Problem: Scale will not turn on
• Solution: Check the batteries
• Problem: Displayedweightuctuatesrandomly
• Solution: Make sure your workspace is stable and
free of any air currents or vibration
• Problem: Displayed weight is inaccurate
• Solution: Perform a calibration adjustment
XI. Error Codes
1. OUTZ - Zero range has shifted. Perform calibration
adjustment. If the problem persists, the load cell may
be permanently damaged due to overloading.
2. EEEEE - Maximum capacity exceeded. Remove the
extra weight to avoid damaging the load cell.
3. No Display - Batteries are low. Replace the
batteries.