AWS Storage Gateway - Configuring Network Adapters for Your Gateway

AWS Storage Gateway User Guide
Configuring Network Adapters for Your Gateway
4. After a few moments, the VM is ready for you to log in.
5. To log in default credentials, continue to the procedure Logging in to the Local Console Using
Default Credentials (p. 252).
Configuring Network Adapters for Your Gateway
In this section you can find information about how configure multiple network adapters for your
gateway.
Topics
• Configuring Your Gateway for Multiple NICs in a VMware ESXi Host (p. 275)
• Configuring Your Gateway for Multiple NICs in Microsoft Hyper-V Host (p. 279)
Configuring Your Gateway for Multiple NICs in a VMware ESXi
Host
The following procedure assumes that your gateway VM already has one network adapter defined and
that you are adding a second adapter. The following procedure shows how to add an adapter for VMware
ESXi.
To configure your gateway to use an additional network adapter in VMware ESXi host
1. Shut down the gateway. For instructions, see To stop a volume or tape gateway (p. 219).
2. In the VMware vSphere client, select your gateway VM.
API Version 2013-06-30
275