AWS Storage Gateway - Connecting Your Volumes or VTL Devices to a Linux Client

AWS Storage Gateway User Guide
Connecting Your Volumes or VTL Devices to a Linux Client
d. Select LTO Tape drive and choose Next.
e. Choose Close to close the Update Driver Software window, and verify that the Driver Provider
value is now set to Microsoft.
5. Repeat steps 4.1 through 4.5 to update all the tape drives.
Connecting Your Volumes or VTL Devices to a Linux
Client
When using Red Hat Enterprise Linux (RHEL), you use the iscsi-initiator-utils RPM package to connect to
your gateway iSCSI targets (volumes or VTL devices).
To connect a Linux client to the iSCSI targets
1. Install the iscsi-initiator-utils RPM package, if it isn't already installed on your client.
You can use the following command to install the package.
sudo yum install iscsi-initiator-utils
2. Ensure that the iSCSI daemon is running.
API Version 2013-06-30
372