AWS Storage Gateway User Guide
Configure Network Parameters
To set a network address
1. Choose Configure Network and press the Enter key. The Configure Network screen shown
following appears.
2. For IP Address, enter a valid IPv4 address from one of the following sources:
• Use the IPv4 address assigned by your Dynamic Host Configuration Protocol (DHCP) server to your
physical network port.
If you do so, note this IPv4 address for later use in the activation step.
• Assign a static IPv4 address. To do so, choose Static in the em1 section and press Enter to view
the Configure Static IP screen shown following.
The em1 section is at upper left section in the group of port settings.
After you have entered a valid IPv4 address, press the Down arrow or Tab.
Note
If you configure any other interface, it must provide the same always-on connection to the
AWS endpoints listed in the requirements.
API Version 2013-06-30
28
To Next Page
Loading...