AWS Storage Gateway User Guide
Using Your Tape Gateway
4. Leave the Device Type options selected, choose Exhaustive Detection, and then choose OK.
5. In the Confirm Exhaustive Detection confirmation box, choose Yes.
6. In the Device Selection dialog box, choose your library and all its drives, and then choose OK. Wait
for your devices to be detected, and then choose Close to close the log report.
7. Right-click your library, choose Configure, and then choose Yes. Close the configuration dialog box.
8. In the Does this library have a barcode reader? dialog box, choose Yes, and then for device type,
choose IBM ULTRIUM V5.
9. In the CommCell browser, choose Storage Resources, and then choose Libraries to see your tape
library.
10. To see your tapes in your library, open the context (right-click) menu for your library, and then
choose Discover Media, Media location, Media Library.
11. To mount your tapes, open the context (right-click) menu for your media, and then choose Load.
Creating a Storage Policy and a Subclient
Every backup and restore job is associated with a storage policy and a subclient policy.
A storage policy maps the original location of the data to your media.
To create a storage policy
1. In the CommCell browser, choose Policies.
2. Open the context (right-click) menu for Storage Policies, and then choose New Storage Policy.
3. In the Create Storage Policy wizard, choose Data Protection and Archiving, and then choose Next.
4. Type a name for Storage Policy Name, and then choose Incremental Storage Policy. To associate
this storage policy with incremental loads, choose one of the options. Otherwise, leave the options
unchecked, and then choose Next.
API Version 2013-06-30
92
To Next Page
Loading...