WOLF NETWORK CONFIGURATION IMPORT / EXPORT FILE
Alarm generation and display re. Traffic
Program status control. If this does not match
the setting, an alarm is generated
Inherent to the FM input (Monitor-RF)
Alarm generation and display re. Music/Speech
status control. If this does not match the setting,
an alarm is generated
Inherent to the FM input (Monitor-RF)
Alarm generation and display re. the presence
of the Alternative Frequencies List control
Inherent to the FM input (Monitor-RF)
ERROR control enable at MPX-1 input
ERROR control enable at MPX-2 input
ERROR control enable at FM input
ERROR control enable at MPX-0 input
ERROR control enable at MAIN input
Decoder Sync loss control enable
Wolf Master Sync loss control enable
Emergency operation status display
Critical operation status display
Backup invalid status display
Communication error display
High internal Wolf temperature display.
These parameters can be used to enable (or
not) UECP data propagation
Diffusion of TA/TP status data
Diffusion of Program Service data
Diffusion of Radio Text data
Diffusion of Decoder Inform. status data.
Diffusion of Music/Speech status data.
Diffusion of Program Type data
Diffusion of Program Identif. data.
TMC_RTPLUS_PROPAGATION=On
Diffusion of Traffic Message Channel and
Radio Text Plus data.
Once you have finished configuring the Wolf Network device, press the Export key to export the Work done stored inside
the device.
You can also check for protocol errors by clicking the Check key.
if you need help about the values admitted by the Parser, press the "?" key visible before the Exit button.
To quit, press the EXIT button.
To Next Page
Loading...