AXIL MD 0274 E - Quick Search; Auto Search

If your device cannot be controlled upon direct code setup or its code is not in the list, program your remote
control using the quick or auto search function. The search function tests all the codes on after another and
fi nds the right one for you.
Quick search
1. Turn on the device to be controlled and aim the remote control at the device.
- If VCR, insert a cassette.
- If SAT, select a program.
- If DVD, insert a DVD.
- If CD, insert a CD.
2. Press the SET button fi rst and hold it down while pressing the respective DEVICE button on your remote
control.
3. When the LED under the corresponding device button lights up, release the buttons.
4. Press the SET button again. The LED starts fl ashing and quick code search starts.
5. Now every 3 seconds press the POWER button on your remote control. Each push on the button transfers
another new fi ve codes. This may take some time (up to 100 times pushing the button, approx. 5 min.).
6. When your device switches off, the correct code range has been found. DO NOT press the POWER button
again, as this would re-start the code search.
7. Press the respective DEVICE button again to exit the current stage, the LED remains light without blinking.
8. Now using the original remote control or device front panel to switch the device ON.
9. Now every 2 seconds press the POWER button on your remote control to see the device’s action. Each
push on the POWR button transfers another new code. This only takes around 10 sec. with 5 times pushing
the button.
10. When your device switches off, DO NOT press the POWER button again, as this would re-start the code
search, check whether the main applications of your device can be operated with the remote control function
keys. If they do, the correct code has been found.
11. Press the respective DEVICE button one or twice to stop/store. LED is off.
12. During the Step 9~10, SET button can be pressed to return the Step 5.
13. During the Step 6, the quick search can be exited by pressing the respective DEVICE button twice.
Auto search
1. Turn on the device to be controlled and aim the remote control at the device.
- If VCR, insert a cassette.
- If SAT, select a program.
- If DVD, insert a DVD.
- If CD, insert a CD.
2. Press the respective DEVICE key on your remote control and release.
3. Press the SET button fi rst and hold it down while pressing the POWER button on your remote control till the
LED under the corresponding device button solidly lights. Release both buttons, LED becomes light and starts
fl ashing. The automatic code search begins.
4. Every fi ve codes are transmitted, there is a 5.0 seconds period between each transmission, approx. 9
min. in total. LED blinks fi ve times for each transmission.
5. When your device switches off, then the correct code range has been found.
6. Immediately press the respective DEVICE key to auto search within these fi ve codes. LED blinks.
7. Now use the original remote control or device front panel to switch the device ON.