AXIL MD 0283 E - Code Set Up; Set Up by Brand Code; Set Up by Manual Search

General Description:
The MD0283E is a new model of preprogrammed universal remote con-
trol which has a extensive code library, powerful function and stable
quality. It features as:
A. Totally 2 device keys: TV, TDT
B. 4 Operation Modes:
Set-up Mode, Manual Search Mode, Auto Search and Display Mode.
C. Back-up memory to keep the set up data no- volatilization.
D. LED ash to indicate when transmission.
E. Set-up indicating LED
F. Volume and Mute Lock function
G. Device Lock function
H. Menu function
Code Set Up
A. Set Up by brand code:
According to the attached Device Brand Code List, nd out the code of
the device brand and device code that you want to control. For example,
you can nd codes for SONY TV: 010, 011, 028, and 030… Then follow
the steps as below:
a. Press and hold the [SET] key. Then press the device key that you
want to control, such as [TV], [TDT] etc.
b. The LED will be on at moment. Then release the pressed both
keys.
c. Enter in the 3-digit Device Code (for example: code 010 under
SONY TV).
d. If the entered Device Code is correct, the LED will be o automa-
tically, then gone to step e. If it is incorrect, the LED will blink twice
and keep being at set up mode, then return to step c.
e. Try if keys on remote control work or not.
If none key works or some key work but most keys work impro-
perly, please try other codes in the same brand (for example: code
028,030 ...under SONY TV), repeat step a-e till you nd one code
which work good enough.
Remark: In the process of setup, if you want to quit from setup mode, please
press device key. (If no key pressed in 10 seconds, the remote control will leave
the set up mode automatically.)
B. Set Up by Manual Search:
After you have set up by device brand code several times, the remote
control still doesn’t work (i.e. The device still can not be controlled by this
remote control), or you can not nd the correct code in the Device Brand
Code List, you can use “Manual Search” to nd out the reactive Code:
a. Power on the device that you want to control. If it is a VCR, it must
be inserted with a tape.
b. Press and hold the [SET] keys. Then press the device key in remo-
te control, such as [TV], [TDT], etc
c. The LED will be on at moment. Then release the pressed keys.
d. Point the remote control to the device, strike the [POWER] key.
the remote control enters into” Manual Search” mode and the LED
keeps ashing.