ENG
e. See if device reacts or not. If it works, turn to step f; If not, repeat
step d every 1 second.
f. Test other keys. If keys work well enough, press the device key
to quit from the search mode. If most keys don’t work well enough,
repeat step d-f to nd the best code.
Remarks:
a. Whenever you want to leave or change search mode, press the device key
to quit, and the LED will turn o.
b. You may use the SET key to change the search direction from forward to
backward or from backward to forward.
C. Set up by Auto Search:
This search is similar to Manuel Search except it transmits power signal
automatically instead of manually pressing the power key during the
search:
a. Power on the device you want to control.
b. Press and hold [SET] key, in the meantime, press and hold the
Device key that you want to control. (for example: TV) for more than
3 seconds and then release them, the auto search begins. The re-
mote control enters into Auto Search, LED ash, and remote control
transmit power signal every 2.0 second automatically.
c. See if device react or not, once the device reacts, press any key
(except SET key) to stop the search.
d. Test if other keys work well enough. If most keys work not good
enough, Auto Search again to nd next reactive code and try until
you nd the best code.
Remark:
a. You must point your remote control to the device that you want to control
during Auto Search.
b. Whenever you want to leave Auto Search mode, press any key (except SET
key) to quit, and the LED will be
O. The search is over.
c. When remote control search through all codes (about 10 minutes), then the
remote control will quit from Auto Search process automatically.
d. In case of you did not stop the search on time when device reacted, you may
use the Manual Search to search back to nd the passed code.
Volume and Mute Lock/Unlock:
a. Strike the device key that the volume and mute key you want to
x such as [TV], [TDT]etc
b. Press and hold the [SET] key, then press the [5] key, then release
the both pressed keys, the LED will blink twice then o, the volume
and mute key of the current device are locked.
c. If you want unlock the current volume and mute key, press and
hold the [SET] key, Then press the [6] key, then release the pressed
keys, the LED will blink twice and then o, the current volume key
and mute key are unlocked.
Device Lock/Unlock
You can use “Device Lock” function to x current device code and this
device code cannot be changed by code set up or code search. You can
use the “Unlock” to quit from this function.
To Next Page
Loading...
